Phone: 609-284-9575
Axidworks
H23-H22 Engine Swap List

H22 - H23 Parts Swap List


The parts for a H23 to H22a Swap. Its a JDM engine so there are quiet a few more things to do than just a basic USDM swap.

      Swap List

  •       1. Timing Belt
  •       2. Manual Tensinor SwapFAQs How To
  •       3. Balancer Belt
  •       4. Oil Pump
  •       5. Water Pump
  •       6. All the Oil seals on the Crank Pulley, and Balancer Shaft
  •       7. Oil Cooler O-Ring
  •       8. Front Thermostate Housing/Sensor(Not On JDM)
  •       9. Clutch
  •       10. Flywheel
  •       11. USDM Fuel Rail
  •       12. External Coil/Dizzy
  •       13. Valve Cover Gasket
  •       14. Valve Adjustment FAQs
  •       15. Altenator Belt
  •       16. P.S. Belt
  •       17. PCV Valve
  •       18. O-Rings On Fuel Injectors
  •       19. Air Filter
  •       20. Transmission CV Oil Seals
  •       21. Vtec Oil Pressure Switch Wire
  •       22. Vtec Solenoid Wire FAQs
  •       23. p13 ECU
  •       24. Fuel Filter
  •       25. Cotter Pins


      Thats a Good ammount of stuff to Replace. Anything else I missed, please add. Ill be using this thread to post for this question. This list is pretty complete, and is a pain to retype out everyday.

      How To Use That JDM Motor Equipment

      1. JDM Dizzy, it can be used with minor modificationLink to JDM Dizzy

      2. You can modify the USDM Fuel line to match the JDM fuel Rail, but it is possible, so dont rule it out.

      When Doing a Swap You Must

  •       1. Wire in Vtec Wires
  •       2. Use a USDM Wire Harness and USDM Fuel Rail
  •       3. Replace all cottor pins you remove
  •       4. Drain all Fluids
  •       5. Reset Timing and do a Manual Tensinor swap
  •       6. Check All gaskets and replace rotted ones


This is a complete list to follow and use.

 

Version 5.1 Axidworks © 2011-2012